This week we will be venting our greens with needle tines. These tines make a hole that is less than an 1/8th of inch. With our greens being completely saturated from the incredible amount of rain that we have recieved this season, there is no room for air movement in the soil. We need to create very small channels for air movement to the root zone. When roots don't have air, they die. This has not been evident yet, but with the warmer temperatures of July upon us soon, trouble could be lurking. This will be a very non-disruptive process to our members and play. We are going to vent all of our greens over then next few days early in the morning as to not disrupt play. The process is simple, we vent the green using the aerifier and needle tines, roll them smooth and then mow the green. The holes virtually dissapear and are of no effect to roll. I realize that the word aerifier starts to scare people, but this is necessary and again is very clean and non-disruptive. Check out the pictures above, the tine is dwarfed by a pen and you can see how small the holes are compared to a golf ball.
Last fall we utilized a “new to us” method of revitilization for our practice tee. Our contractor TDS, fraize mowed the surface of the tee to remove organic matter as well at to aid in leveling. The tee was then aerified and seeded to a new variety of creeping rye grass. We chose this type of turf grass as research shows rapid recovery and a low growth habit. We were able to get some great growth in the fall, but the tee is still not ready for traffic and full use. The plan is to utilize the mats until growth has filled in some of the voids etc. We will then begin to slowly set up hitting areas on the grass tee. For a while we will alternate between grass and the mats with a 50/50 ratio of use. Once the grass tee is established and is in adequate recovery mode, the practice areas will be back to normal. As always our membership’s patience is appreciated as we try to improve these areas for use.
hi very nice, turf grass,thanks
ReplyDelete